Second Generation Ascots > Tech Section
Front Brake Lever 'pull'
(1/1)
Bucko:
The front brake lever on my 84 ascot was getting a bit 'soft'. I did a full bleed and a small amount of air came out. The 'pull' has firmed right up but the lever still travels a full two inches before it gets firm (measured from the handlebar to just where the ball at the end of the lever starts). Anyone else have a similar experience?
J6G1Z:
Use a zip-tye to hold the lever back by about an inch & leave it overnight.
Check it the next day & see if it improves.
J.
Bucko:
I've tried the lever trick on multiple bikes over the years (including the ascot) and never had it improve anything. I think it's a bit of an urban myth.
scott s:
It's worked for me before, but only to get the last little bit of air out.
Get one of the vacuum type brake bleeders. That "pulls" the fluid out/down towards the caliper vs. "pushing" the air down, so to speak. Once I learned to use mine properly, it makes brake bleeding easier and a one man job.
Navigation
[0] Message Index
Go to full version