Author Topic: FT side stand issues  (Read 1532 times)

thumperdh

  • Full Member
  • ***
  • Posts: 142
FT side stand issues
« on: March 28, 2014, 09:16:08 pm »
Is the side stand on the FT as useless as I think it is?

The angle that my bike sits at while on the side stand is downright scary, it looks like it's no more than about 5 degrees off of vertical. I haven't used it for more than about 6 minutes in the 6 or so years I've had the bike now. For a while, i took it off completely.

I've always had the idea of hacking off about 1/2 to 1" off of the overall length of it and welding a new foot onto it. Has anybody done any modifications to give theirs a little more lean? Heat it up and bend it? Any ideas? Or do you all do the same thing that I do and just use the center stand?
1982 FT500
Conti Classic Attack tires
Foam filter mod
Round headlight
Rejetted carb
Progressive springs
Supertrapp muffler
Thumperstuff header

J6G1Z

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1568
Re: FT side stand issues
« Reply #1 on: March 29, 2014, 07:50:07 am »
I've never had any issue with my side stand on my stock FT. My lowered FT is another story. I had 1/2" sectioned out of the end of the side stand & then welded back together. Remove your side stand & take it to a GOOD welding shop. (You want to make sure that the weld has good penetration & is solid so your bike doesn't fall over) The guy that did mine, took it to the wire wheel first & removed all the paint from the end. He then took a straight edge & a soap stone & drew a straight line down the length of the tubing. Then off to the chop saw & chopped a half inch out of it. He then took the ends to the bench grinder & ground a nice bevel around the freshly cut ends. After that, he realigned the soap stone reference line & welded it back together. After it cooled, he dressed up the weld lightly & I took it home to paint it. You can't even tell that it was sectioned & now the bike has a nice lean to it. If you check out my FT/CBR Hybrid post, I think there is a pic or two of it.

I always store my bikes that have center stands, on their center stands to keep them straight up & down. When I'm out & about riding the bike, I use the side stand. I've never noticed that my FT has any problem. I own an FJ1200 Yamaha that the side stand almost had the bike standing straight up & down. I placed it on its side stand once at a gas station & it high sided on me. Damn that pissed me off! Then when I picked it up, the side stand collapsed & it went over on the other side. When I got home I ordered a new side stand spring & examined the side stand issue. I ended up taking my small angle grinder to the forward kickstand stop boss & removed some material until the side stand angled farther forward a bit. Now the bike has some lean to it & the side stand is leaning forward instead of straight up & down.

There you have two possible solutions to your problem. Have you lowered your bike, or have lower profile tires on it?

Good luck
J.

PS. Here is a pic for you: http://ascot500.com/index.php?topic=79.msg309#msg309
« Last Edit: March 29, 2014, 08:01:50 am by J6G1Z »