« previous next »
Pages: [1]

Author Topic: FT500 Watt output  (Read 11162 times)

wkruse

  • Newbie
  • *
  • Posts: 2
FT500 Watt output
« on: October 07, 2014, 02:55:55 pm »
Hello,

I have been Lurking for some time and I enjoy this forum!

The first question that I have is that I want to know the Wattage output from the FT Ascot. Everything stock.

Then I wanted to know if there was a way that I could run 90W at one time with no problems with battery and such.

Thanks
« Last Edit: October 07, 2014, 03:38:33 pm by wkruse »
Logged

J6G1Z

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1598
Re: FT500 Watt ourput
« Reply #1 on: October 07, 2014, 03:14:00 pm »
Welcome to the forum. I hope that you are able to find what you are looking for.

I'm not very up to speed on the FT Ascot electrical system. From what I recall there are two electrical systems. This link will take you to the wiring diagram & some other information on the dual electrical system: http://ascot500.com/index.php?topic=126.0

Good luck
J.
Logged

Lefty

  • Full Member
  • ***
  • Posts: 215
Re: FT500 Watt output
« Reply #2 on: October 07, 2014, 05:53:00 pm »
I was looking through my manual & the spec for alternator output is 7amps max @ 5000RPM. I'm not seeing a wattage output. What are you trying to do, run a brighter headlight?
For more output, you could have your stator rewound by an alternator shop, more wire winds=more output, guys with dirt bikes that want to make them streetable do this all the time.
Oh yes, welcome to the boards!
Logged

scottly

  • Full Member
  • ***
  • Posts: 176
  • Humboldt, AZ USA
Re: FT500 Watt output
« Reply #3 on: October 07, 2014, 07:30:41 pm »
My manual states that the alternator is rated at 170W @ 5000 RPM, on page 1-3. Where did you see 7A, lefty?
The minimum load the bike draws is about 78 W:
headlight on low =55W
taillights=16W
speedo and tach lights=6.8W
This also assumes that the battery has recovered from the drain of the electric starter.
Logged

Lefty

  • Full Member
  • ***
  • Posts: 215
Re: FT500 Watt output
« Reply #4 on: October 07, 2014, 09:18:23 pm »
Oh I see it now, chalk it up to 3 14hr shifts & not enogh sleep.
So the FT puts out 170W at 5000 RPM, My queStion is still what kind of load are you talking about increasing, and have you researched stAtor winding for more output?
Logged

wkruse

  • Newbie
  • *
  • Posts: 2
Re: FT500 Watt output
« Reply #5 on: October 08, 2014, 12:16:27 pm »
Thank you for the quick responses.

I am going to be running a dual light headlight setup with 30w (single light, low) and 60w (double light, high)

I will also be running a small LED Tail light that wont pull too many watts.

Logged

J6G1Z

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1598
Re: FT500 Watt output
« Reply #6 on: October 08, 2014, 12:52:51 pm »
Check out the "FILES" section on the Yahoo FT Ascot Owners Group: https://groups.yahoo.com/neo/groups/honda-ascot/files

You are looking for the title: FT500 Additional Lights I will attempt to attach the PDF below.

Looks like it can probably be done. If you use LED turn signals, you will need an LED flasher unit like this one: https://www.superbrightleds.com/moreinfo/motorcycle-accessories/lf1-s-pin-universal-motorcycle-electronic-flasher/193/841/

Good luck
J.
Logged
Pages: [1]
« previous next »