« previous next »
Pages: [1]

Author Topic: Cylinder head removal  (Read 11114 times)

jeremie

  • Newbie
  • *
  • Posts: 10
Cylinder head removal
« on: August 12, 2015, 06:25:10 pm »
Hi,

I try to remove the cylinder heads to change the gaskets that have dried.

How do we remove them without removing all the engine? What's the easiest way to do it?

Thanks,

Jeremie  ;D
Logged

jeremie

  • Newbie
  • *
  • Posts: 10
Re: Cylinder head removal
« Reply #1 on: August 12, 2015, 06:40:13 pm »
« Last Edit: August 12, 2015, 07:59:24 pm by jeremie »
Logged

scottly

  • Full Member
  • ***
  • Posts: 176
  • Humboldt, AZ USA
Re: Cylinder head removal
« Reply #2 on: August 12, 2015, 08:28:27 pm »
You have a VT500? There is a different tech section for them. If you had an FT500 I could help...
Logged

jeremie

  • Newbie
  • *
  • Posts: 10
Re: Cylinder head removal
« Reply #3 on: August 12, 2015, 10:33:47 pm »
Yeah, I just noticed that I posted in the wrong tech section ... Sorry about that.
Logged

AndreLindholm

  • Newbie
  • *
  • Posts: 16
Re: Cylinder head removal
« Reply #4 on: August 24, 2015, 06:48:55 am »
I'll hijack this thread a little bit.
My Ft motor is leaking, seems to between the head an the cylinder and cylinder and block. And around the left side cover.
The side cover I can do with removing the the engine from the frame I guess, But to remove the cylinder, do I need to lift the engine? I have a new set of gaskets laying around.
And while I have my engine opened is there anything you guys recommend looking at, and maybe replace while I'm at it? 
« Last Edit: August 24, 2015, 06:55:06 am by AndreLindholm »
Logged

WTF304

  • Full Member
  • ***
  • Posts: 174
Re: Cylinder head removal
« Reply #5 on: September 03, 2015, 07:08:09 pm »
You don't have to remove the engine at all ... it all can be done still in the frame
Logged
Pages: [1]
« previous next »